Lego Technic 1977

Technic sets were first introduced in Europe in September 1977 under the name Technical Sets. Advertising, such as in catalogs, called the new theme "Technical Sets" although the boxes didn't have any name on them.

These sets, intended for older children, expanded the Lego range into much more complex mechanical models, or -as early advertising stated- models "as technical as the real thing". The original series consisted of 4 models, including a 590 piece Auto Chassis, and 2 supplementary sets. In Europe they were given 850 and 870 series set numbers.

Several of these new elements, such as the cross axle and universal joint were holdovers from the earlier Gear wheel sets and were changed very little. Several other elements were new, more refined versions of the Gear Wheel elements, such as the technic beam that replaced the 2 x 4 brick with holes. Still other elements were entirely new, such as gears, the connector peg and piston rod. The 2 original supplementary sets included examples of all of the new elements.

example parts

The crown gear:
The original crown gear is a good example of how the new Technic elements replaced earlier elements. The Samsonite and Lego gear wheels could act as either a pinion or crown gear due to the relatively large size of their teeth. However, the smaller Technic gears required a new design. The crown gear featured a tooth similar in profile to a claw, (or a "bird's head" according to the 1976 UK patent application). Acting as a pinion it could mesh with the bottom of the tooth or as a crown gear with the top of the tooth.

UK patent 1543128 UK patent 1,543,128

The piston rod:
These new elements were intended not only to provide alternatives to the traditional stud and tube coupling but to provide realistic technical functions. A good example of the purpose of these new elements is given in the 1976 patent application for the piston rod and brick. 2 piston rods on either end of a cross axle could act as a eccentric connection to a gear and a 2 x 2 brick with a bearing replacing the tube underneath the brick. This arrangement could translate the reciprocal movement of the piston into the rotational movement of a gear or wheel and served as the basis for the technic engine until 1990.

patent 4124949 US patent 4,124,949

853 Auto Chassis:
The large auto chassis models have always been among the largest and technically complex sets and serve as a good indicator of Technic state-of-the-art. Although relatively unsophisticated by todays standards, the 853 Auto Chassis was by far the most technically complicated Lego set in 1977. It had a 4-cylinder in-line engine, 2-speed transmission, front wheel rack and pinion steering and adjustable seats. The new elements offered interesting new possibilities but the 853 as well as other first generation models utilized a large percentage of typical Lego bricks and plates and used rather traditional construction techniques. The use of the Technic beam as a true beam would be several years away. Because there were still so few specialized elements, technical functions tended to be rather bulky and limited. The rack and pinion steering, for example, was built from 2x2 turntables and 2x1 beams and the seats were built entirely from standard bricks.

1977 sets:
850 Fork Lift Truck
851 Tractor
852 Helicopter
853 Car Chassis
870 Motor with battery Box
871 Supplementary Set

By Isodomus

Additional information